#IMPRIMANTE 3D CUBE PRO DUO SOFTWARE#

Genius! Good timing, too.I'm trying to collect some good profiles for common machines. I don't think time maters and the materiallength is just used to be sure there will be enough left in the cartridge to print the E1 at the end of some of the setting is for extruder 1) I can make a kiss file (with no comments) and it will read and start to print. so if you add this to the header and change the material type as needed( ) the printer will print. « Reply #12 on: May 16, 2013, 04:31:50 AM »Īfter some more testing, it will read the file after it is decrypted and you can change Checksum to NO and it will not complain about that. I also have the blowfish key that is used to decrypt it.

#IMPRIMANTE 3D CUBE PRO DUO SOFTWARE#

Here is the information I have on the bfbe files that are generated by its software I will do what ever I can to help engineer a way for the owners over come this locked down system. As a BFB owner i would like to see theses machine sorted.

We are starting to see the CubeX owners emerging into the market place. Space Art | 3D Modeling | Blown Glass Sculpture | Blog | Bio Then I watched as all the complaints came flying in. Important job in the studio and just didn't want to take the chance of having the printer down. More than a few bricked their machines flashing the new firmware that wasn't adequately tested prior to release. Then the printer doesn't work as well as it did previously and, surprise, you can't roll-back to the earlier firmware. Finally come out with a fix for this problem or that and, gee, you have to flash the firmware to use it. They do a lot of stuff that herds you into where they want you to be. Haven't heard anything about the CubeX and G-code capability but, if it does read it and prints well using it, I'd strongly wager that those days are also numbered.

Probably a contributing reason why they dumped the line. The 3D Touch on the firmware required to parse their encrypted garbage from Axon3 would read G-code. the software for the printer is.not good. Yea I can not see what they are outputting, but the printer will work with regular g-code(I am told) so I was wondering if someone did the work to figure it all out, If not we will have to try until we get it working.

Imprimante 3d cube pro duo